Koffler Electrical Mechanical Apparatus Repair, Inc
527 Whitney St
San Leandro, CA 94577 USA
Phone: 510-567-0630
Fax: 510-567-0636
Email: info@koffler.com
Website: http://www.koffler.com
|
|
|
|
|
Item # 111943, Leeson Three Phase C Face Less Base Explosion-Proof Motors
|
|
|
|
|
|
1 HP, 3450 RPM, NEMA Frame 56C, 208/230/460 V, - Three Phase
- C Face less Base
- Division I, Division II, Class I, Groups C & D-Class II, Groups F & G With Conduit Box
Explosion-Proof For Hazardous Locations
Underwriters Laboratories and Canadian Standards Association Listed
General Specifications:
These explosion-proof motors are designed and approved for application in hazardous environments having certain explosive gases or materials present.
Application Notes:
These motors must be applied in accordance with the National Electrical Code, Article #500. A partial listing of explosive agents is noted below. Consult NFPA Publication 497M for a complete listing. Please note subheads above each column for qualifications of LEESON motors.
|
|
|
|
|
|
|
|
|
No LEESON motors are listed for Class I, Group A or B.
Class I
Group A: Acetylene
Group B: Butadiene, ethylene oxide, hydrogen, propylene oxide, manufactured gases containing more than 30% hydrogen by volume.
Group C: Acetaldehyde, cyclopropane, diethyl ether, ethylene.
Group D: Acetone, acrylonitrile, ammonia, benzene, butane, ethanol, ethylene dichloride, gasoline, hexane, isoprene, methane (natural gas), methanol, naphtha, propane, propylene, styrene, toluene, vinyl acetate, vinyl chloride, xylene.
Class II
Group E: Aluminum, magnesium and other metal dusts with similar characteristics.
Group F: Carbon black, coke or coal dust.
Group G: Flour, starch or grain dust.
|
|
|
|
- Consult factory for 50 Hz derate.
- Rugged mechanical construction meeting all requirements for safety. UL and CSA listed.
- Double shielded, pre-lubricated ball bearings are standard.
- All motors have inherent automatic overload protection.
- NEMA 1.0 Service Factor except as noted.
- Explosion-proof conduit box included at no extra cost.
- Normally-closed thermostats are standard on cast iron motors.
- Division I areas are environments where a hazard is present continuously or would be subject to fire or explosion if the hazard was present as a result of an accident or uncommon occurrence.
- Division II areas are environments where the threat of fire or explosion is not normally present and not likely to result in the event of an abnormal occurrence.
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
